PRS SE Custom 24 tone settings
⚡ Match a tone on this guitar- neckHumbucker
- middleNo pickup
- bridgeHumbucker
How do you dial in a specific tone on a PRS SE Custom 24?
Pickup output and position decide how hard the front of an amp gets driven, which means the PRS SE Custom 24 needs different amp settings from a guitar with the opposite layout to land on the same sound. That difference is where most tone-chasing goes wrong: the settings were right, but they were written for someone else's pickups.
Name the song you are chasing in the tone matcher and Tonelify returns the settings for this exact electric guitar, not the settings the original artist used. Those are two different things: the recording was made on gear most players do not own.
PRS SE Custom 24 pickup combinations
The 3-way blade switch picks the pickups and the push/pull tone knob picks humbucking or single coil mode, so the SE Custom 24 has six sounds. The first two columns are from PRS's wiring diagram for the SE Custom 24; the last is Tonelify's suggestion for each.
| Switch and tone knob | Pickups on | Tonelify's pick for |
|---|---|---|
| Position 1 (down), knob pushed in | Treble (bridge) pickup, humbucking | Metal and hard rock rhythm, high gain leads |
| Position 1 (down), knob pulled up | Treble (bridge) pickup, single coil mode | Brighter rhythm at lower gain, country and indie lines |
| Position 2, knob pushed in | Treble and bass pickups, humbucking | Clean chords and crunch rhythm with more body |
| Position 2, knob pulled up | Treble and bass pickups, single coil mode | Funk and clean rhythm |
| Position 3 (up), knob pushed in | Bass (neck) pickup, humbucking | Blues and rock leads, full jazz clean |
| Position 3 (up), knob pulled up | Bass (neck) pickup, single coil mode | Clean arpeggios and lighter blues |
PRS SE Custom 24 full spec sheet
Every specification PRS lists for the current SE Custom 24 on its product page, from the fret wire to the strings it ships with.
| Spec | PRS SE Custom 24 |
|---|---|
| Body | Solidbody, maple top with a flame maple veneer, shallow violin carve |
| Back | Mahogany |
| Neck | Maple, multi-ply, Wide Thin shape, set into the body |
| Truss rod | PRS Double-Acting |
| Frets | 24, PRS SE Standard fret wire, .104" wide and .046" high |
| Scale length | 25" |
| Fretboard | Rosewood, 10" radius, bird inlays |
| Neck width | 1 11/16" at the nut, 2 1/4" at the body |
| Pickups | 85/15 "S" treble and bass |
| Controls | Volume and push/pull tone, 3-way blade pickup switch |
| Bridge | PRS Patented Tremolo |
| Tuners | PRS designed tuners with wing buttons |
| Hardware | Nickel |
| Strings | PRS Classic 10-46, standard tuning |
| Case | Gig bag |
SE Custom 24 vs SE Custom 24-08
The two share the body and neck; PRS lists different pickups and switching.
| Difference | SE Custom 24 | SE Custom 24-08 |
|---|---|---|
| Pickups | 85/15 "S" | TCI "S" |
| Pickup switch | 3-way blade | 3-way toggle |
| Single coil mode | Pull the tone knob up | Two mini-toggle coil-tap switches |
| Knobs | Volume and push/pull tone | Volume and tone |
PRS SE Custom 24 specifications
- Scale length
- 25"
- Construction
- Mahogany back with maple top, set wide-thin maple neck
- Bridge
- PRS patented tremolo
- Pickup layout
- HH
- Controls
- 3-way blade with push-pull coil tap, volume and tone
What the PRS SE Custom 24 panel means when you dial it in
A 25" scale, mahogany back with maple top, set wide-thin maple neck. That sits between the two common scales, 24.75" and 25.5", so the strings hold a little more tension at pitch than on a short scale and a little less than on a long one. Humbuckers push a hotter, thicker signal into the input, so they reach a given amount of saturation at a lower gain setting. Controls: 3-way blade with push-pull coil tap, volume and tone. PRS patented tremolo, so anything in the original that moves the pitch by hand can be played rather than approximated with an effect. Every setting Tonelify writes for this instrument names the pickup position it was dialled in on, because moving the selector changes both the level hitting the amp and the frequency balance it arrives with.
What pickups does the PRS SE Custom 24 have?
Two humbuckers, one at the neck and one at the bridge. In shorthand that is HH. Pickup output and position change how hard the front of an amp is driven, which is why the same song needs different gain settings on this guitar than on one with the opposite layout. Tonelify accounts for that when it writes the numbers.
PRS SE Custom 24 questions
What does the push/pull knob do on the PRS SE Custom 24?
It is the tone knob, and it also switches the pickups between two modes. PRS's operating instructions for the SE Custom 24 say: push-pull tone pot down, humbucking mode; up, single coil mode. PRS's wiring diagram takes the coil wires of both pickups to that one knob, so pulling it changes both pickups at once. The knob still works as a tone control in either position.
How many pickup sounds does the SE Custom 24 have?
Six: the 3-way blade switch has three positions and the push/pull tone knob two modes for each. PRS lists the switch as position 1 (down), treble pickup; position 2, treble and bass humbucking pickups; position 3 (up), bass pickup. Pull the tone knob up and each of those runs in single coil mode instead. The table on this page lists all six with what Tonelify would use each one for.
Which switch position is the bridge pickup on the SE Custom 24?
Position 1, with the blade all the way down. PRS calls the bridge pickup the treble pickup and the neck pickup the bass pickup, so position 3, with the blade all the way up, is the neck. Position 2 in the middle runs both together.
What pickups are in the PRS SE Custom 24?
85/15 "S" pickups in both the treble and bass positions. PRS describes them as uncovered pickups designed to its specifications, with clarity and extended high and low end, for modern applications. The SE Custom 24-08 uses TCI "S" pickups instead.
What is the best SE Custom 24 setting for clean tones?
Tonelify's picks, not PRS's: the bass (neck) pickup with the tone knob pulled up for single coil mode gives the lighter, more open clean that suits arpeggios, and the middle position pulled up suits funk and clean rhythm. For a fuller clean, such as jazz chords, push the knob back in on the neck pickup. Keep the guitar's volume on full and set the clean level on the amp.
What is the best SE Custom 24 setting for blues and classic rock?
Tonelify's picks: the bass (neck) pickup as a humbucker for blues leads, with the tone knob turned back a little to round off the top, and the treble (bridge) pickup as a humbucker for classic rock rhythm. The middle position as humbuckers sits between the two for crunch chords. On a pushed amp, turning the guitar's volume down cleans the sound up without touching the amp.
What is the best SE Custom 24 setting for metal?
Tonelify's pick: the treble (bridge) pickup with the tone knob pushed in, so it runs as a humbucker, and the tone knob on full. Single coil mode sends less level into the amp and gives up the hum cancelling of the second coil, both of which work against a high-gain sound.
Should I change my amp settings when I pull the tone knob up?
Usually a little. In single coil mode the pickup sends less level into the amp, so the same gain setting sounds cleaner and the same volume a touch quieter. If a crunch tone loses its edge after pulling the knob, add a little gain on the amp rather than turning the guitar up. Tonelify's settings for a song name the pickup and mode they were written for.
What is the scale length and neck of the SE Custom 24?
PRS lists a 25" scale length, 24 frets and a Wide Thin maple neck, set into the body, with a rosewood fretboard of 10" radius and bird inlays. The nut is 1 11/16" wide and the neck 2 1/4" wide at the body. The 25" scale sits between the 24.75" of a Les Paul and the 25.5" of a Stratocaster.
What strings and tuning does the SE Custom 24 ship with?
PRS lists PRS Classic 10-46 strings in standard tuning: E, A, D, G, B, E. It comes with a gig bag.
Does the PRS SE Custom 24 have a tremolo?
Yes, the PRS Patented Tremolo, which PRS describes as designed for tonal fidelity, player comfort and tuning stability. The tuners are PRS designed tuners with wing buttons, and the hardware is nickel.
What is the difference between the SE Custom 24 and the SE Custom 24-08?
The switching and the pickups. The SE Custom 24 has 85/15 "S" pickups, a 3-way blade switch and a push/pull tone knob for single coil mode. The SE Custom 24-08 has TCI "S" pickups, a 3-way toggle switch and two mini-toggle coil-tap switches, down for humbucker mode and up for single coil mode, with a plain volume and tone. The comparison table on this page lists both from PRS's product pages.
What amp settings suit a PRS SE Custom 24?
The HH layout on this instrument is what decides it. Humbuckers push a hotter, thicker signal into the input, so they reach a given amount of saturation at a lower gain setting. That changes the gain setting more than any other control, which is why the same song needs different numbers on this instrument than on one with the opposite layout.
Do I need to change my settings when I switch pickups on the PRS SE Custom 24?
Yes. Moving from a neck position to a bridge position changes both the output level hitting the amp and the frequency balance, so a setting dialled in on one pickup rarely holds up on the other. Every set of settings Tonelify returns names the pickup position it was written for.
Does Tonelify support the PRS SE Custom 24?
Yes. Name it in the tone matcher along with the song you are chasing and the settings come back adapted to it. Gear does not need to be in the catalog for a match to run.
Sources
Panel, specifications and dates checked against these on .
- PRS: SE Custom 24 product page
- PRS Support: SE Custom 24 (incl. Floyd) and SE Standard 24 wiring diagram
- PRS: SE Custom 24-08 product page
PRS's product pages refused requests from here, so they were read in the Internet Archive's copy of 9 July 2026; the wiring diagram and its operating instructions were read on PRS's support site. The pickup picks are Tonelify's, not PRS's: PRS gives no settings per style.
More PRS gear
Similar guitars from other makers
Settings for the song you are chasing
Name a song and Tonelify reads the documented rig behind the recording, then writes the settings for a rig with the PRS SE Custom 24 in it. A first plan starts with 7 days free, $0 today.