Boss DD-8 Digital Delay settings
⚡ Match a tone on this pedal- E.Level
- Feedback
- Time
- Mode
How do you dial in a specific tone on a Boss DD-8 Digital Delay?
Time and modulation effects sit at a specific point in a chain and change character completely if they move. Settings for the Boss DD-8 Digital Delay come with the position in the signal path, not just the knob values, because a delay in front of a driven amp and the same delay in a loop are two different sounds.
Name the song you are chasing in the tone matcher and Tonelify returns the settings for this exact pedal, not the settings the original artist used. Those are two different things: the recording was made on gear most players do not own.
Settings for this unit only ever use controls it actually has, because its front panel is stored in our gear database. You will not be told to set a knob that is not on the unit.

Free download
Printable cheat sheet: PDF and PNG
The slapback, tape solo, dotted 8th, shimmer and reverse settings from this page, together on one sheet with short tips. The PDF prints on white; the PNG is the dark version for your phone.
Starting settings on the Boss DD-8 Digital Delay
Positions as clock times, since the knobs carry no numbers: 12:00 is the middle of the travel. They are where to begin, not Boss's numbers: move one control at a time from here.
Slapback
Mode ANALOG, Time 8:00, Feedback 8:00, E.Level 12:00. One quick repeat right behind the note, for rockabilly, country and early rock and roll. BOSS's manual calls ANALOG a mild analog delay with 20 to 800 ms of delay time, so with Time this low the repeat sits close to the note. Feedback this low gives a single repeat. Tonelify's positions, not BOSS's.
- Mode ANALOG
- Time 8:00
- Feedback 8:00
- E.Level 12:00
One repeat, close to the note.
Tape echo for solos
Mode TAPE, Time 11:00, Feedback 11:00, E.Level 11:00. BOSS's manual says TAPE adds the modulation that is distinctive of a tape echo unit. Three or four repeats that sit under a lead without washing it out. E.Level below 3:00 keeps the repeats quieter than the note: BOSS says at three o'clock the effect plays at the same volume as the direct sound. Tonelify's positions.
- Mode TAPE
- Time 11:00
- Feedback 11:00
- E.Level 11:00
Repeats under the lead.
Dotted eighth with tap tempo
Mode STANDARD, Time tapped, Feedback 11:00, E.Level 2:00, TAP DIVISION set to dotted eighth. The rhythmic delay for picked eighth notes. BOSS's reference manual gives this exact case: with TAP DIVISION set to a dotted eighth note (the WARM position in the setting mode) and the pedal pressed at quarter-note intervals, the delay is a dotted eighth at that tempo. Set the division once, then hold the pedal for two seconds to enter tempo mode and tap. Turning the Time knob afterwards resets the delay to the knob's position. Tonelify's positions.
- Mode STANDARD
- Time tapped
- Feedback 11:00
- E.Level 2:00
TAP DIVISION: dotted eighth.
Shimmer ambient
Mode SHIM, Time 2:00, Feedback 1:00, E.Level 12:00. BOSS's manual calls SHIM a delay with pitch-shifted sound added, with 200 to 800 ms of delay time. Long, slow chords and single notes let the shifted repeats build. Watch Feedback past this point: BOSS warns that oscillation may occur at certain knob positions. Tonelify's positions.
- Mode SHIM
- Time 2:00
- Feedback 1:00
- E.Level 12:00
Slow chords, let it build.
Reverse only
Mode REVERSE, Time 12:00, Feedback 9:00, E.Level MAX. BOSS's manual says that with E.Level at MAX in REVERSE mode only the effect sound is output, at the same level as the input, so every note swells in backwards. REVERSE runs from 300 to 5000 ms. Play slowly and leave space for the swell. Time and Feedback positions are Tonelify's.
- Mode REVERSE
- Time 12:00
- Feedback 9:00
- E.Level MAX
E.Level MAX: effect sound only.
The looper
Turn the Mode knob to LOOP and press the pedal to record; the CHECK indicator flashes red. Press again to play back (green) and again to overdub (orange). Press twice in quick succession to stop, and hold the pedal for two seconds to delete. BOSS gives 40 seconds for mono input and 20 seconds for stereo, and in LOOP the E.Level knob sets the playback volume while Time and Feedback do nothing.
Chasing one song? Name it and the matcher writes that song's settings for the Boss DD-8 Digital Delay.
Boss DD-8 tap division by Mode knob position
In the TAP DIVISION setting mode the Mode knob picks the note value, not the delay type. The delay you get when you tap quarter notes is BOSS's, read from the illustration in its reference manual.
| Mode knob position | Delay when you tap quarter notes |
|---|---|
| STANDARD (also SHIM, MOD, GLT, WARP) | Quarter note (factory setting) |
| ANALOG | Half note |
| LOOP | Whole note |
| WARM | Dotted eighth note |
| TAPE | Eighth note |
| REVERSE | Quarter note triplet |
| +RV | Eighth note triplet |
Boss DD-8 output methods
BOSS's reference manual gives five ways to connect the DD-8, each with a different result.
| Method | Connection | Result |
|---|---|---|
| Normal | In A, out A | Mono delay |
| Long | In A, out B | Delay time doubled |
| Direct Mute | In B, out A | Effect only, for an amp's effects loop |
| Stereo | In A (or A and B), out A and B | Stereo delay |
| Effect + Direct | In B, out A and B | Effect from A, direct from B |
What controls does the Boss DD-8 Digital Delay have?
The Boss DD-8 Digital Delay has 4 controls on its front panel: E.Level, Feedback, Time and Mode.
Boss DD-8 Digital Delay specifications
- Front panel
- E.Level, Feedback, Time, Mode
What the Boss DD-8 Digital Delay panel means when you dial it in
Its controls are E.Level, Feedback, Time and Mode, and settings for this pedal are written against those names rather than a generic level, tone and gain.
Boss DD-8 Digital Delay questions
What modes does the Boss DD-8 have?
Eleven, per BOSS's manual: STANDARD (clear digital delay), ANALOG (mild analog delay), TAPE (tape echo modulation), WARM (mild digital delay), REVERSE (delay played backward), +RV (delay with reverb), SHIM (delay with pitch-shifted sound added), MOD (digital delay with modulation), WARP (a dreamlike sound), GLT (a machine-gun-like sound while you hold the pedal) and LOOP.
What is the delay time of the DD-8?
20 to 800 ms on most modes, per BOSS: REVERSE runs 300 to 5000 ms, SHIM 200 to 800 ms and GLT 10 to 400 ms. With the long delay output connection every range doubles, to 40 to 1600 ms on the standard modes and up to 10000 ms on REVERSE. Tap tempo covers 67 to 10000 ms.
Where should E.Level be on the DD-8?
BOSS's manual says that at the three o'clock position the effect plays at the same volume as the direct sound, so anything below 3:00 keeps the repeats under the note. In REVERSE mode, E.Level at MAX outputs only the effect sound.
How do I use tap tempo on the DD-8?
Hold the pedal switch down for at least two seconds until the CHECK indicator lights green, press it in time with the song at quarter-note intervals, then hold it for two seconds again to finish. BOSS says tempo input is not possible in WARP, GLT or LOOP, and that a footswitch on the TEMPO/EXP jack can tap the tempo instead.
How do I set the DD-8 to a dotted eighth delay?
Through the TAP DIVISION setting. BOSS's reference manual says to connect only the INPUT-B jack, hold the pedal switch while you insert the plug into INPUT-A, turn the Mode knob to the division you want and press the pedal to save. The WARM position is the dotted eighth note; the factory setting is quarter notes. The setting stays when the power is off.
How do I get longer delay times on the DD-8?
Use the long delay connection: guitar into INPUT-A and the amp on OUTPUT-B. BOSS's reference manual says this doubles the delay time on every mode.
Can the DD-8 run in stereo?
Yes, mono in to stereo out, or stereo in to stereo out with both inputs and outputs used. BOSS offers three stereo types, picked in a setting mode with the Mode knob: Panning, Wide stereo and Stereo, linked parallel delays for A and B, which is the factory setting.
What does the Carryover switch on the DD-8 do?
BOSS's manual says it selects whether the delay sound remains (on) or does not remain (off) when you turn the effect off, so with it on the repeats ring out instead of cutting off.
How long can the DD-8 looper record?
40 seconds with mono input and 20 seconds with stereo input, per BOSS. You can overdub, stop by pressing the pedal twice within a second, and delete by holding it for two seconds.
Can I use an expression pedal with the DD-8?
Yes, a Roland EV-5 or BOSS FV-500H, FV-500L or EV-30 on the TEMPO/EXP jack. BOSS says it controls E.Level, Feedback and Time, and that you set only the maximum of each range by turning the knobs in the setting mode; the minimum cannot be set.
What is the TWIST function on the DD-8?
An effect BOSS describes as an aggressive sense of rotation, played from an external footswitch: the ring pedal of two FS-5U units, or switch A of an FS-6 or FS-7. BOSS says it does not work in LOOP mode or with only one FS-5U.
Why is my DD-8 oscillating?
BOSS's manual says oscillation may occur with certain input sounds or when the Feedback knob is set at certain positions. Turn Feedback down until it stops. In GLT mode Feedback sets the depth of the effect instead.
How much power does the DD-8 need?
9 V DC at 100 mA, per BOSS's current manuals, from a PSA series adaptor or a 9 V alkaline battery that BOSS says lasts about 3.5 hours of continuous use. The jacks double as the power switch, so unplug the input when you are done.
Is there a printable DD-8 settings cheat sheet?
Yes. The cheat sheet on this page puts all five settings on one page with the mode for each, and short tips under them. Download the PDF to print it, or save the PNG to your phone.
Where does the Boss DD-8 Digital Delay go in the signal chain?
After the drive stage. Running a time or modulation effect into a distorted input smears the repeats into the distortion instead of layering them over it, which is why this kind of pedal usually belongs in an effects loop where the amp has one.
Does Tonelify support the Boss DD-8 Digital Delay?
Yes, and its front panel is stored, so settings only ever reference controls this pedal has: E.Level, Feedback, Time, Mode. You will not be told to set a knob that is not there.
Sources
Panel, specifications and dates checked against these on .
More Boss gear
Similar pedals from other makers
Settings for the song you are chasing
Name a song and Tonelify reads the documented rig behind the recording, then writes the settings for a rig with the Boss DD-8 Digital Delay in it. A first plan starts with 7 days free, $0 today.