Tonelify
Black Friday40% off yearly
PedalDistortion

Boss DS-1 Distortion settings

⚡ Match a tone on this pedal
Front panel3 controls
  • Tone
  • Level
  • Distortion
The controls on the Boss DS-1 Distortion, drawn in a row rather than in the real panel layout.

How do you dial in a specific tone on a Boss DS-1 Distortion?

A drive pedal is not an amount of gain, it is a shape. The Boss DS-1 Distortion changes what reaches the amp's input, so where it sits in the chain and how the amp is set behind it matter as much as the pedal's own controls. Settings here cover both ends: the pedal, and the amp underneath it.

Name the song you are chasing in the tone matcher and Tonelify returns the settings for this exact pedal, not the settings the original artist used. Those are two different things: the recording was made on gear most players do not own.

Settings for this unit only ever use controls it actually has, because its front panel is stored in our gear database. You will not be told to set a knob that is not on the unit.

Starting settings on the Boss DS-1 Distortion

Positions on a 0 to 10 scale, with 5 at twelve o'clock. They are where to begin, not Boss's numbers: move one control at a time from here.

Starting point

Level at unity, Tone 5, Distortion 5. BOSS's manual says to set Level so there is no volume difference between the effect and the straight guitar sound, so switch the pedal on and off as you turn it. Tone is a tilt control: BOSS's product page says clockwise increases highs and decreases lows, and counterclockwise does the opposite. The Dist knob sets the depth of the distortion and the length of the sustain. Start in the middle and move one knob at a time.

Boss DS-1DS-1 starting point
  • Level unity
  • Tone 5
  • Distortion 5

Level at unity: as loud on as off.

Boost for a driven amp

Level 7 to 8, Tone 4 to 5, Distortion 0 to 2, into an amp that is already breaking up. BOSS's product page says the DS-1 works great as a booster at low distortion settings, from a mild boost for driving amps and pedals, and that the Tone control is particularly effective for keeping low-end definition with vintage-style amps. BOSS's article on distortion pedals says a low gain distortion into a driven amp pushes the preamp for rich harmonics and sustain. Here the amp does most of the distortion.

Boss DS-1DS-1 as a boost
  • Level 7 to 8
  • Tone 4 to 5
  • Distortion 0 to 2

The amp makes most of the distortion.

Punk and rock rhythm

Level at unity, Tone 4 to 5, Distortion 6 to 7, into a clean amp. BOSS's DS-1 article says it is great as the main distortion for clean and mildly driven amps, and BOSS's article on distortion pedals says that into a clean amp the pedal becomes an amp in a box and the amp only gives the volume. The article also says the DS-1 has a slight dip in the lower midrange, so it suits amps with a strong midrange, such as classic Marshall and Fender tweed models.

Boss DS-1DS-1 rhythm
  • Level unity
  • Tone 4 to 5
  • Distortion 6 to 7

Clean amp. Turn the guitar down to clean up.

Lead

Level a little above unity, Tone 6, Distortion 8 to 10, so the solo comes up over the rhythm. BOSS's manual says turning Dist clockwise gives deeper distortion and a longer sustain, and BOSS's product page says the hard-edged attack stays clear even at maximum distortion, for heavy rhythms and cutting solos. If the lead turns harsh, bring Tone back towards 5 before lowering Distortion.

Boss DS-1DS-1 lead
  • Level above unity
  • Tone 6
  • Distortion 8 to 10

Single coil guitars

Level at unity, Tone 3 to 4, Distortion 7 to 8. BOSS's article on distortion pedals says a single coil guitar such as a Telecaster sounds thinner and more nasal, and needs more gain and a low-end boost from the pedal, while high output humbuckers give the fullest, thickest results. On the DS-1 the low end comes from turning Tone counterclockwise, which BOSS's manual says cuts the higher frequencies for a softer, warmer sound.

Boss DS-1DS-1 single coils
  • Level unity
  • Tone 3 to 4
  • Distortion 7 to 8

Tone left of noon for more low end.

Chasing one song? Name it and the matcher writes that song's settings for the Boss DS-1 Distortion.

Match a song to this pedal7 days free, $0 today

What controls does the Boss DS-1 Distortion have?

The Boss DS-1 Distortion has 3 controls on its front panel: Tone, Level and Distortion.

Boss DS-1 Distortion specifications

Front panel
Tone, Level, Distortion
Released
1978

What the Boss DS-1 Distortion panel means when you dial it in

Its controls are Tone, Level and Distortion, and settings for this pedal are written against those names rather than a generic level, tone and gain.

Boss DS-1 Distortion questions

What does the Tone knob on the Boss DS-1 do?

It tilts the sound between lows and highs. BOSS's manual says turning it clockwise cuts lower frequencies for sharp sounds, and counterclockwise cuts higher frequencies for softer, warmer sounds. BOSS's DS-1 article calls it a tilt EQ that affects lows and highs with a single control, unlike tone controls that only cut highs.

What does the Dist knob on the DS-1 do?

BOSS's manual says it controls the depth of the distortion and the length of the sustain: clockwise gives deeper distortion and a longer sustain. BOSS's product page says its range runs from a mild boost for driving amps and pedals to full-throttle gain.

How should I set the Level knob on the DS-1?

So the pedal is as loud on as off. BOSS's manual says to set it so there is no volume difference between the effect and the straight guitar sound. Go above that for solos, or when you use the DS-1 as a boost.

Can you use the Boss DS-1 as a boost?

Yes. BOSS's product page says it works great as a booster at low distortion settings, and that its Tone control keeps the low end defined with vintage-style amps, which often sound muddy when driven with other distortion pedals. Start with Distortion low and Level high.

Why does my DS-1 sound bad?

Often it is the amp. BOSS's article comparing the DS-1, SD-1 and BD-2 says the DS-1 is only as good as what you run it into: with a small, cheap amp you may wonder what the hype is about, and with a great-sounding amp its distortion melds with your base tone. Also check the Tone knob: fully clockwise it cuts the lows for a sharp sound.

What amp works best with the DS-1?

BOSS's DS-1 article says the DS-1 has a slight dip in the lower midrange, so amps with a prominent midrange, such as classic Marshall and Fender tweed models, may give better results. With a mid-scooped amp such as a blackface or silverface Fender, it suggests the Normal input or turning off the bright switch, if the amp has one.

Does the DS-1 clean up with the guitar's volume knob?

Yes. BOSS's product page says turning down the guitar's volume cleans up the tone without introducing muddiness, and that the DS-1 does not mask the sound of different guitars, pickups and styles.

What is the difference between the DS-1, SD-1 and BD-2?

BOSS's article puts it this way: the DS-1 is a razor-sharp, hard-edged distortion; the SD-1 is an asymmetric overdrive with a mid hump that gives a warm, creamy tone into a clean amp and tightens a crunchy Marshall; the BD-2 sits between the two, with a stiffer attack than the SD-1 and a brighter, more scooped sound.

What is the difference between the DS-1, DS-1W and DS-2?

BOSS's DS-1 article says the DS-1W Waza Craft of 2022 has a revised discrete analog circuit with two modes: Standard gives the original DS-1 sound, and Custom a fatter sound with more midrange, a retuned tone control and more gain. The DS-2 Turbo Distortion of 1987 has Turbo I, close to the DS-1 with a softer attack, and Turbo II, which adds a gain stage and a mid boost for leads.

How long does a battery last in the DS-1?

BOSS's manual gives about 50 hours of continuous use on a carbon battery and 80 hours on an alkaline one, with a current draw of 10 mA. The INPUT jack doubles as the power switch, so unplug the cable when you stop playing. It also takes a BOSS PSA series adaptor, sold separately.

Why does my DS-1 distort or the light go dim?

Usually a weak battery. BOSS's manual says the CHECK indicator goes dim when the battery is low and should be replaced, and that a battery running extremely low can make the sound distort. It adds that, because of the analog circuit, the indicator may be lit or unlit when you first turn the power on.

How big and heavy is the Boss DS-1?

73 mm wide, 129 mm deep and 59 mm high, and 360 g with its battery, per BOSS's manual. The input impedance is 1 M ohm and the output impedance 1 k ohm.

When did the Boss DS-1 come out?

In 1978, BOSS's first distortion pedal. BOSS's product page calls it the top-selling BOSS compact pedal ever, with its original design unchanged, and BOSS's DS-1 article puts sales at over 1.5 million. BOSS's article comparing it with the SD-1 and BD-2 says it has been in constant production since 1978.

Who played the Boss DS-1?

BOSS's DS-1 article names Mike Stern, Joe Satriani, Steve Vai, George Lynch, John Frusciante and Mark Speer of Khruangbin, and quotes producer Jack Endino saying Kurt Cobain was using a DS-1 on Nirvana's Bleach in 1989.

Where does the Boss DS-1 Distortion go in the signal chain?

In front of the amp input, before any time-based effects. Drive pedals interact with what the amp is already doing, so the amp's own gain setting is part of the answer and cannot be ignored when the pedal is dialled in.

Does Tonelify support the Boss DS-1 Distortion?

Yes, and its front panel is stored, so settings only ever reference controls this pedal has: Tone, Level, Distortion. You will not be told to set a knob that is not there.

Sources

Panel, specifications and dates checked against these on .

More Boss gear

Similar pedals from other makers

Settings for the song you are chasing

Name a song and Tonelify reads the documented rig behind the recording, then writes the settings for a rig with the Boss DS-1 Distortion in it. A first plan starts with 7 days free, $0 today.